Purchased this last week. Arrived well packaged and as described. Carefully prise the screen surround away from the laptop. 4 screws to remove with very small cross head screwdriver. Fold the screen to lay it onto the keyboard, the plug is at the bottom, keep it close to the original pivot line. Carefully lift the tape from away from the connector, when near the connector slowly pull down to disengage it. Remove the screen. Lay the new one onto the keyboard and carefully engage the connector. If in doubt the tape is still sticky enough apply a small tab of electrical tape over a slightly wider area. Rotate the screen back up to the top cover, engaging onto the positioning tabs. Replace the screws. Refit the bezel starting at the bottom of the screen carefully snapping it into place as you go. Skill Level: Novice, just take a little care about what you are doing.